Miller XR-S Control #300601

Miller XR-S Control #300601

The XR-S Control is a simple, cost-effective push-pull wire feeder for fabrication and manufacturing for use with a push-pull gun. It is good for feeding aluminum wire.

True Torque Feed Motor

Push-pull design provides continuous push force to the wire while the gun motor controls the speed at the gun. The motors work together to provide accurate and positive wire feed speed without wire shaving or deformation.

Trigger Hold

Reduce fatigue by allowing operators to weld without holding gun trigger.

Wire Jog Control

Allows wire to be threaded through gun cable without energizing weld output.

Adjustable Wire Run-in Control

Allows arc start fine-tuning and reduces wire stubbing or arc flaring which can result in contact tip burnback.

Input Power 24 VAC, 5 A, 50/60 Hz

Wire Feed Speed 50–900 ipm (1.3–22.9 m/min.)

Wire Type and Diameter Capacity

Aluminum .035–.062 in. (0.9–1.6 mm) Solid Wire .035–.045 in. (0.9–1.2 mm)

Drive roll kit 268850 required to run 1/16 in. (1.6 mm) wire

Maximum Spool Size Capacity 12 in. (305 mm)

Input Welding Circuit Rating 400 A at 100% duty cycle System duty cycle is limited to gun rating

Net Weight 42.5 lb. (19.2 kg)

Dimensions H: 16 in. (406 mm) W: 9.5 in. (241 mm) D: 21.25 in. (540 mm)

PROCESSES

• Aluminum Welding
• MIG (GMAW)

• XR™-S Control #300601 Spec Sheet

Product Questions and Answers

Have a question about this product? Submit your question using the form below